[. . . ] The Sharp Microwave Ovens are designed to either stand neatly on a kitchen counter top or to be built into a fitted kitchen cabinet using the surround. The kitchen cabinet must be of the following dimensions as shown in Fig. Make sure that the back panel D is always fitted to ensure the correct ventilation of the oven and that the ventilation gap C must be 45 mm as shown in Figs 1 and 2. [. . . ] (For Continental use) The electric outlet must be installed at 150 mm high from the floor of the built-in cabinet and at 50 mm from the right wall of the built-in cabinet as shown in Fig. The mains plug must be accessible after installation or the oven must be connected to an electric circuit provided with an all-pole switch (contact gap no less than 3 mm) to disconnect the oven in case of danger. A safety-device such as a fuse in the installation may be used as a switch. Caution: Make sure that the oven always keeps its balance to avoid falling over. Attach the aluminium sheet C onto the back panel D of the built in cabinet as shown in Fig. Set the spacing brackets 1 on the shelf along the right and left walls of the kitchen cabinet, keeping a distance of 17 mm between the front end of the shelf and the spacing brackets, and attach them with the four screws 0, as shown in Fig. Caution: The arrow marks on each spacing bracket should be pointing towards you. Insert two tabs of the intake duct 3 into the slits of the back plate E. And install the intake duct 3 to the back plate E with one screw A as shown in Fig. Loosen screw F holding the outer wrap to the rear of the oven as shown in Fig. Install the exhaust duct 2 to the rear of the oven by tightening two screws A and F (loosened at step 6) as shown in Fig. Loosen screw G holding the back plate E to the rear of the oven as shown in Fig. Let the power supply cord pass through the hole of the lower side of the intake duct 4 as shown in Fig. Install the intake duct 4 to the rear of the oven with two screws G (loosened at step 8) and H (removed at step 9) as shown in Fig. [. . . ] Check location by measuring distance between right and left built-in frame side elements 9. Install the second built-in frame element 8 over the built-in frame side elements 9 at bottom edge of the oven. Secure the built-in frame element 8 through the holes of the built-in frame side elements 9 to the kitchen cabinet with two screws B as shown in Fig. [. . . ]